Posts by Jmarch23

cooling could very well be an issue, however over time pluging in your adapter and unpluging it could do it too.....when u plug in ur ac even though u dont see it there is a small shock when the ac meets the dc jack over time the heat...

I can pretty much guarentee it is not the LCd, if all the leds stay on when the laptop is powered this means that post is not being completed, therefore no output on any monitor/LCD this is common, and fixable, but the simple fact that...

The simple fact that he says it goes right to "No Os Found" kinda means the controller is gone.....and he does say he set the bios to raid...controller is bad...find a good shop that will replace it

you could always use the bezels from a normal dv6k...not the special edition but the normal black one, ive seen these bezels on ebay

On your laptop there are four screws covered by a rubber nipple....remove the ruber nipple, pop off the front bezel carefully. inverter is UNDER not behind, but under the lcd, long skinny green thing..

TomMicroUSA....by the way its not so much the voltage that will hurt him but the amps being higher might not go over so well, specifically with a 3rd party adapter...

Ill be very honest with you i would never use any adapter other than the manuf. issued adapter. Y you ask, well because ive seen som many of these 3rd party adapters kill laptops, do it at your own risk but i saw no way return that peice...

Yes as will almost every DC jack out there.....developing cold solder is not outta the ordinary for any dc jack. The zd8000 is no exception, while it has many more pins it still will develop cold solder...If this turns out to not be your...

ViolatorX vbmenu_register("postmenu_2668597", true); if youre still in need of help contact me via email, i can get you up and running no problems....your motherboard has a minor flaw but it can be fixed....

This is a common issue with the ole 7ks....develops a short inside the unit where the dc meet the motherboard, can be easily fixed up....get a new Dc jack and some soldering equipment, email me for details....