Posts by WRL2

PhoenixBIOS 4.0 Release 6.0 BIOS Revision V122 1.00.10 KBC/EC Firmware Revision 1.00.05 VBIOS Revision VER008.017M.097.000-2004/11/02   FastTrak 100 "Lite" (tm) BIOS Version 2.02.1.5   2047M System RAM (2 x 1GB...

... going slightly off topic, back in 2004 when the NP8790 was the King of Notebooks, the Sager Forums especially the 8790 Tech section was the in-place to be for Q&A. I think everything I ever had problems with or whatever, someone had...

Not sure if this is the right place to mention this but I've removed two working 512MB PC2700 SODIMMs from my defective Sager 8790.   (Mainboard failed to due the on-board ATI Mobility Radeon 9700 overheating /...

Ok .. here's an update. Have taken the 8790 to bits (and I mean just that), there are parts everywhere. Some of the screws are so small I dare not breath for fear of blowing them away. The "bad" news is .. I have found a...

Has any 8790 owners with a dying or dead motherboard ever attempted to open the unit up and replace with a new motherboard? I've just ordered a new 8790 (D87P) motherboard as the screen even seconds after powering from cold is filled...

Has anyone got a new (preferably new) or if not at least in good condition, a Car Charger/Power Adapter (CAR-ED1150-2) for a Sager 8790.

using my Sager 8790, the built-in Graphics Card is the ATI Mobility Radeon 9700. on the rear of the 8790 is a round PS/2 Mouse type connector which I have a connecting cable as supplied with the 8790 from new. this connector plugs...

I have a Nokia E51 and can transfer files i.e. pictures, music (MP3) files etc. no problem via Infrared to the laptop. I want to know how do I send files from the laptop to the phone? is the Infrared that's built into the laptop one...

I have a Nokia E51 and can transfer files i.e. pictures, music (MP3) files etc. no problem via Infrared to the laptop. I want to know how do I send files from the laptop to the phone? is the Infrared that's built into the laptop one...

i tried the drivers from (http://www.techspot.com/drivers/driv...ormation/3416/]) but the error message i get is that i need to set the device to use a Standard VGA Driver to continue--the ATI setup/installation then quits. how do i do...