Posts by Boboche

I don't really mind people like powerpack; been around since the BBSes on C=64 so got my share of that type with time . Well I can tell you that the 1505 ATI doesn't fit directly, you need to cut off the screw holder between the two...

I tried the E1505 ATI in but I think I damaged the board when trying to drill it a little so it would slide in (one of the card holder was obstructing by about 2mm, usually PCB's signal aren't routed that close to the edges (other than...

Great! thanks!... so it answers the question about my x1400... I really fried it

Hey I was checking on ebay, can you fit a go 6800 from an inspiron 9300 into the 9400? from what I read everywhere it's almost the same board minus new chipset. By looking at the card it looks like it fits but just want to make sure if...

Yah but that's just some shit plastic

Okay here goes. PS. Can do macros shots up to 8megapixels on 1cm square if needed.

go7900 taken from a E1705/9400 Dell inspiron

on GPU cards or in general? If you've seen that on a GPU card, could you point me in a specific area of the board, that would help out

Bad solder spots would have refluxed with the heat, I will inspect it I got a 60-100x portable mag gadget with a led on it so you can trace anything visual with that, but I suspect if that would be the problem, it would be within the...

interresting, Tried this, now the card is ****ed vertically as well in the black areas... when I move the cart (i.e. try to flex it a little) I see reaction according to the bending... can't quite figure out if its the GPU or within the...