Posts by NetMavrik

Start by only adjusting the highest multipliers voltage. Try 1.4 volts at first. When you go below 1.4 volts, the payoff in reduced temperatures isn't as great as going from 1.550 down to 1.4. I actually have mine set at 1.4 most of...

Good luck in getting the HDD to power off. I never have with XP. There is always something accessing the drive. Sysinternals has a File System Monitor. You can use it to see what is accessing your HDD and when. XP SP2 adds something...

1 hour and 2 minutes? That is really bad. I get at least two. I must be brief, but here are some suggestions. Make sure that it is throttling down to 800Mhz. CrystalCPUID can misbehave sometimes. I run MobileMeter, and have it...

The new 62 watt mobile operates at a max voltage of 1.4. I am running my DTR at 1.325 at 2.2Ghz. In my opinion, my DTR at 1.325 is better than the new mobile chip at 1.4. I bet the new mobile chip will run quite a bit lower than 1.4,...

I would use 1.03 BIOS and fan firmware S2.

ATITool doesn't work. It outputs a file size of only 1.5K. That is way too small. I will only use an ATI utility when I do it.

Yes, it will. All of my systems are XP, so I don't have a way of setting up DOS on my USBKEY.

I have had to postpone my research a little. I have an idea about how to enable PowerPlay, but it involves flashing my videos cards BIOS with one that I modified. I obtained a BIOS from a Dell Inspirion 9100 and was able to compare it...

Hello dpawn and wbeck. I guess us three are the only ones who have attempted this. O well. I didn't choose 1500mhz because if it being in the middle of anything. When I ran my benchmarks and burn-in tests, I determined it to be...

wbeck Your steps 1 - 4 are correct. That is exactly what I did. I changed that threshlold a little too. As for the PowerPlay stuff, I am still working on it. I am making progress, but it is very dificult. I don't see anyway...