New Posts  All Forums:

Posts by exabytehd

The XPS gen 2/M170 will definitely not work, my XPS gen 2 also did not work with the geforce go 6800 vanilla. My M1710 with the geforce go 7900 gs also does not work, but atleast doesnt have the issues my M170 had, it is detected as...
in the display properties go to advanced (where you select the resolution), and then under the monitor properties and uncheck hide modes this monitor can't display, if that doesnt work, also try maybe some drivers from laptopvideo2go,...
yes it is, at 60Hz, which is why you can only get 16-17Hz, the really only annoying part is the cursor refresh rate, otherwise it is like moving stuff around @ 17FPS with 160 Mhz of bandwidth you can run almost any resolution (as long...
if you really need the extra real-estate, then another option is the IBM-T221 or the Viewsonic VP2290b, they are usually going for ~$1000 on e-bay right now for good ones, it will work with the M90 at the full 3840x2400, but only at 16...
just thought I would add, the comp I am running it on full time has 2xdual-link DVI but it came with the wrong cable, it came with the two ended single link DVI that connects to only one of the inputs on the monitor so I am only able to...
with the right vid card/cables you can run any resolution @ 41Hz, and a higher refresh rate at lower resolutions, The highest resolution the monitor takes that is single link with a good refresh, is 1920x1200, on a top of the line comp...
I use my audigy 2 zx noteobok on my M17170 using a dock and a PCI PCMCIA adapter.
So I finally got a M1710 to replace my XPS gen 2 with the vid bios bug where it would only work with 1 resolution on two driver versions, but unfortionately it is detected as single-link, my 6800 ultra/7800 gtx was detected as dual link,...
my 7900gs is highly overclockable, I get over 9000 on 3dmark05 @ 630/1200 stable, with no artifacts.
make sure DMA is enabled on the dvd drive, go to the system control panel, then the hardware tab, device manager. Under IDE/ATAPI controllers, go to secondary IDE channel and verify under advnaced settings that Device 0 is Ultra DMA...
New Posts  All Forums: