Posts by BoredSilly

I'm trying to get the output from sensors to display more then just the two slots of ram I have . I ran sensors-detect but all that managed to do was show up my two slots of ram. Has anyone using a 8890 managed to get sensors to detect...

Same things happened here, drops to 7%

Can you display your hijackthis output.

Try the new cat 4.8 beta drivers at : http://downloads.guru3d.com/download.php?det=836 I've read they give better results then the current 4.7 drivers. I'm at work so can't.

Not good ) :

I had the exact same problem and its not a problem with mobile meter but actually your installation (actually microsofts promise ata controller driver). If you have two disks and access your d drive (e.g do a search) while mobilemeter...

Do you have two hard drives installed by any chance?

Okay following krobotkin’s information I decided to run a few tests and have managed to narrow down the problem. First I think this locking up will only occur if you have two hard drives (in my case C: and D: ) If I monitor the second...

Does anyone else have this problem? If I run mobilemeter and then do a search or something that hits the hard drives heavily the whole system will freeze up and I have to powerdown.

Quote: Originally Posted by Denmicster Hey BoredSilly, you said that Mobile Meter works on a Sager 8890? Were you referring to the temperature monitor as well? Because when I run it, I just get a flat line graph...