Posts by HKPolice

No, that's AS epoxy to fill in the gap between the pipe and fins. Quote: Originally Posted by KingStyle I dont think the AS5 on top of the heatpipe is doing any good except making hot spots for you.

It's fully assembled right now and I don't wanna take it apart again unless something goes wrong, lol There's a thin (maybe 1mm thick) plastic film stuck onto the bottom of the keyboard, covering the metal base. I've cut parts of it...

List of mods: -VID4 mod = 1.596v max, prime stable @ 2.66Ghz with 1.58v, 2.53Ghz @ only 1.468v both FULLY assembled, no removal of keyboard or any other parts -Slightly lapped HSF base -AS5 of course -Washers on the mounting...

Pin mod the 755 with VID 4 volt mod, works for me, just gets too hot while priming @ 2.66ghz, so I use CHC to limit it to 2.53Ghz @ 1.468v. It's prime stable there and I bet I could of lowered the voltage some more, but with the VID mod,...

Got proof? Quote: Originally Posted by j.clausse Nvidia just annonces the 7800 ultra for desktop. This will be released very very quick, maybe they'll release the 7800 go ultra soon too. The new nvidia g72...

Ya, that 3Ghz P4 is no match for the Dothan, stupid review.

Quote: Originally Posted by mmzmaster I have been running my Samsung 17" @ 100Hz for 2 weeks. lol Weird, my samsung starts to show artifacts above 79Hz, did you just type in 100Hz or did you slowly...

How can you tell which brand the screen is??

I tried that, it actually heated up the CPU and it was around 48C IDLE...... wtf. Quote: Originally Posted by prona Try using RMClock's Run HLT on OS Idle command. That might help a little bit. USB does use a lot of...

You can't pin mod a 533FSB cpu, read the sticky.