Posts by G/H

Maybe. But it's pretty much just tweezers and a good eye!! Vid1 is the vid1 hole to a ground hole and Vid2 is the vid2 hole to a ground hole.

Yea, that's normal. you can use rmclock to drop your voltage to 1.42 and that will drop your temps a little (if its stable). Mine is stable at 1.372 (my temps hover around 60 to 61 under load). When I had my voltage at 1.404 my temps...

The 7800 rules. Sometimes I cant believe I'm playing games that look this good on a laptop. I just spent 2500 dollars on my desktop and hardly use it anymore.

You can get 70-90 bucks for the 1.6Dothan on ebay

If you really wont to lower the temps you need to take your card apart, scrape off Dell's thermal solution, find a suitable copper shim (I used a .02 (24 guage) copper sheet and cut a square about the size of the GPU die) use some AS5...

A good way to check is to play a game and then check the peak reading on the task manager - it will read the highest amount of memory used.

The new militia map on CS:S uses over a gig of memory. Between 1000 and 1100 MB.

That laptop would be at least $3000 dollars from Dell, Maybe their stolen.

These cards are pretty tough. The throttle is there to protect the card, so your not going to fry it.

My card throttles at 104(fangui) 110(CP) even though it says 115 in the control panel. My most graphics intense games usually are in the high 80's sometimes I'll hit the 90's. I challenge anyone to run 3dmark05 just the pixel shader...