Posts by multitek

You dont nesessarily have to pull the battery. Look for a 3 pin jumper beside or close to the battery. The board will be markes cmos. Pull out the jumper move it one pin over to close the ouside pin whatever the case may be. Then put it...

Tip of exacto knife to lift edge. Then green tea tree oil to remove guck. Most other products like nail polish remover will ruin the paint. Make sure that top section is not a refurb or it will be differnet paint under neath. They dpray...

Make sure you look at the back of the laptop when its closed. Make sure that the SEAM BETWEEN the two half of the LCD is closed all the way.(the space between the hinges) Sometimes they have not snapped all the way closed allowing light...

I want to know if anyone has done this swap on xps laptops. I am posting a horror story of a 4 month system exchange, which I just got yeasterday. I now have to get another exchange because the exchange they sent me was a refurb, not a...

Use Dameon with the image loaded and download the program SR7 Stop v1.0 . Run it AFTER the image is loaded. Beeen doing it forever. You dont even need a no cd crack. Havent payed for software since the vic 20 and dont plan to start now....

Just use it on battery power. When it get low, just turn off computer an charge it up again.

She has your email account. If she wanted to actually talk, dont you think she would have emailed you with her own email and info? Not her dell rep number?

Its most likely you lcd. The video drivers would not effect it till after boot and it shows line durring boot process boot screen. Its the monitor

I talked to a Dell rep and got the inside scoop. I was told that the 170 and 1710 monitors are IDENTICLE. The only difference is the clearcoat screen on the top layer surface that changes the birightness. There is more of a glare on the...

Dude, peel off the plastic film protective covering. Thats why it looks like shyte. I have seen this soooo many times on different sites. Grab a pin or something sharp, and lift off edge of plastic from edge of metal cover. Thats it.