Posts by stefanoda

1. I currently own a 120gb SSD Disk in my Clevo notebook and love it! I would love to get one (or more) for my desktop as well in the near future 2. Did not make my mind up yet on the brand. The one I have is an Intel and I love the...

Quote: Originally Posted by i_max2k2 my mistake for not reading enough, but this so far has been the most useful post, thank you, so I should create a new vid and then mark it for 1.32 or watever voltage required...

well, i know it's been said countless times, but i'll repeat it again.. changing the voltage LABEL in nibitor does exactly that.. it changes only the LABEL it uses to represent what the actual VID voltage is.. it DOESN'T alter the...

Quote: Originally Posted by zzpulp I have previously dealt with modding drivers to overclock. Its a little more complicated finding out the faults but if you can wait, then just give me the name of the driver you want...

Hi all.. I used to have the 94.20 overclocked to 640/590 with ati tool and everything was working fine.. except bioshock, which would show black boxes. So I decided to install the new 165.01 beta drivers. I get no black boxes, but for...

I can set my core as high as 670 mhz without problems... but you better have a dual heat pipe and a good AS5 layer before you attempt that... alas, my stupid rev 1 memory won't clock higher than 590 without giving me artifacts...

Rev 1 memory clocks won't go higher than 600.. forget 740.. he must have a bad rev 0 board..

Quote: Originally Posted by zzpulp I think 650+ is pushing the limits of the card. You can increase the core voltage all you want and produce more heat (provided the voltage actually increases) but it wont do you any...

Quote: Originally Posted by zzpulp This whole time I was thinking the rev1 was hampered in both its core clock memory frequency. Since you have a core of 630 I am now just assuming its only the memory. Your core isn't...