New Posts  All Forums:

Posts by paulv7

I have a dvr-k12ra and it locks up about half the time I put a CD in it as well. I talked to Sager's help people and they insisted it was Nero. I uninstalled everything having to do with Nero and it still happened. Actually it seemed to...
I have a 8890 with 16in screen. I use Maya on it all the time. I use Shake and After Effetcs on it sometimes but haven't done any heavy editing on it yet. My 2 cents if your doing heavy video editing you want to get raid or...
8890 has 1. I use it often actually. When I need to change settings on our router or switch I plug into them through the serial cable.
I do a lot of modeling in Maya on my 8890. Anything from poly models up to heavy NURBS modeling. The thing runs great. Much better than any PC I have ever owned. I haven't rendered out any animations on it yet (only single frames)...
I'm sorry but that is a GOOD joke. This is what I was going to do but chickened out. My company is a month behind on our Internet/phone VoIP bill. I was going to come in this morning and pull the router and NBX offline and...
plugging headphones into the headphone jack on the side of the 8890.
Hey quick update on this. I emailed Sager about it and they said they have found out "nero easy packet reader software" can cause this issue. I don't have that installed so in my case that was not the problem. I recently...
You might want to also check your OpenGL and Direct3d settings in your drivers. If those are set to high and your graphics card can't render out frames fast enough it can cause artifacts. Also might want to check make sure you have...
litehedded: I would have but at the time PC Torque called me about it then I called Sager since the return label had Sager's mail address and phone. Laura@PCTorque: I assure you that was not the intent of my post, thank you for...
I edited this just to add this note to the top. This issue was resolved by PC Torque. They went above and beyond anything they had to do for me. You can see what happened if you read the whole thread. I just wanted to post my...
New Posts  All Forums: