Posts by ataxy

Setfsb wont work, your only option is the pin modding.

well since the lead (graphite) in the pencil is conductive rubbing the pencil on the top of a resistance will reduce its resistance permitting more voltage to go true still i would gladly have a look at your unfinnished mod for...

as i said failing circuitry tend to overheat as it fails

i have never seen a dvd burner burn a groove in a dvd

honestly you would need to figure which of the small resistance on the board you would have to pencil in order to slightly raise the voltage and which type of lead pen to use in order to properly affect the voltage. now that i gave...

Quote: Originally Posted by matchbox2022 Do you know why that is? realistically theres no reason for it too I thought. Anyone else around that might know? I don't know where zzpulp has been these days, he seems to...

yes well its a dell... i have noticed that myself, that as the gpu fails the temp will progressively start to reach higher and higher max temp until it finally fail for good

i use this to make sure its enable

10 min at 200c is to much in my point of view and yes it seems to be the end slowly you can always try to recook it check this post i made http://www.notebookforums.com/post3125830.html

hum gpu look likw a similar problem to the 7950gtx in the m1710 but gpu is onboard on your baking is a bit more touchy