Posts by esub

.......and it is runningt at 3.4ghz. Those temperatures come from MBM heat monitor. thanks again.

I almost forgot to mention that I have a whissling sound coming from it. It is killing me....

Hi everybody, I hope everybody is doing good. Ge|atinousFury: Do I have the confidence to open up the two-days-old laptop? I guess, NOT. You know, If I was going to fix it by myself after paying such amount of money then I would...

G_Omaha: Right now I don't hear any roaring or screaming fans and temperature has never got lower than 58C. I haven't notivced any blinking cap-lock or num-lock lights but should I wait until see one of them? Being close to maximum...

Right now I cannot give you the idle temp. because I have program running on it and I don't want to stop it. As soon as it is done with the code I will ppost the idle temp and also prime95 results. YOu are right about prime95 and I...

thank you guys for quick responses, I appreciated. Gomaha: Bratag: Dom02: I don't know how heavy is that of running a mathematical software on it. Is it heavier than 3D gaming? I have even seen 60C and I am getting close to 68C...

Howdy Denmicster, I would perfectly fine if I was happy with the 8890. I would like to solve this issue as soon as possible so that I can enjoy the Spring little bit without constantly worrying about the system. As a matter of fact...

Hello, I have been reading this htread for a while and frankly I got scared.Intel site gives Thermal Spec:68°C for 3.4 P4 processor and right now my system hasn't seen any lower degrees than 58. Only one mathematical program runs on...

I haven't seen any lower than 58 Hi everybody, I know everybody here feds up with such questions but I got to ask. I have run MATLAB (mathematical software) for couple hours right now and I haven't seen the temperature any lower...

Hi everybody, I have been following for quite a time now this forum and I have learned a lot and still learning. After reading all the threads about 8890 I decided to order one and it is on its way. My question goes to former 8890...