D610 dead except when in docking station ... The D610 is new to me so I am a bit cautious at this stage about dismantling and applying power flying lead wise bu ...

Sea_Eagle · 11-03-2009, 10:34 PM

The D610 is new to me so I am a bit cautious at this stage about dismantling and applying power flying lead wise but I am prepared to do this to make sure that power does get past the connector on the motherboard. I did however check very thoroughly with ohm meter and resoldered joints.

Unfortunately I am leaning towards the same conclusion as you. Just hoping there still are a few options to pursue.

Just found that I can obtain a D600 motherboard for a few cents plus transport any chance that is close enough to replace a D610 mobo.

I just think it is pity for good 'resources' going to the dump so I will push the reppair a bit, is not overly important (retired)

Sea_Eagle · 11-04-2009, 07:10 AM

I am starting to look for schematic diagram for the D610, found this crowd:

http://www.laptopschematic.com/dell-...matic-diagram/

Has anybody dealt with them.

If so, is the material good quality?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with docking Station Please	megkjo	HP, Compaq and Voodoo Notebooks	1	09-15-2007 09:49 AM
Docking Station..	Skillz	Dell Home (Inspiron, XPS, Studio)	8	09-08-2006 04:43 PM
WTB For my Dell D610: 512MB Ram, Docking Station,case, anything else you want sell	DaMaN	Notebooks For Sale - Wanted	2	06-29-2006 03:31 PM
i8600, dead docking station??	jwilker	Dell Notebooks - General	9	04-22-2006 09:18 AM
Looking for a docking station/hub	gettinI9300	Dell Legacy (single-core notebooks)	1	02-17-2006 09:32 PM

Notebooks For Sale

User Links

Latest Pricing

Top Posters

Todays Top Posters

Fastest Benchmarks

Latest Benchmarks

11-03-2009, 10:34 PM	#1
Sea_Eagle Registered User Join Date: Apr 2008 Posts: 7 Credits: 262	The D610 is new to me so I am a bit cautious at this stage about dismantling and applying power flying lead wise but I am prepared to do this to make sure that power does get past the connector on the motherboard. I did however check very thoroughly with ohm meter and resoldered joints. Unfortunately I am leaning towards the same conclusion as you. Just hoping there still are a few options to pursue. Just found that I can obtain a D600 motherboard for a few cents plus transport any chance that is close enough to replace a D610 mobo. I just think it is pity for good 'resources' going to the dump so I will push the reppair a bit, is not overly important (retired)

11-04-2009, 07:10 AM	#2
Sea_Eagle Registered User Join Date: Apr 2008 Posts: 7 Credits: 262	I am starting to look for schematic diagram for the D610, found this crowd: http://www.laptopschematic.com/dell-...matic-diagram/ Has anybody dealt with them. If so, is the material good quality?