New Posts  All Forums:Forum Nav:

Cam Not Working

post #1 of 6
9/17/05 at 10:21pm
Thread Starter 
Hi, for some reason the webcam on my 8790 isn't showing up at all. Its nowhere to be found in the device manager, and after i install the drivers and try to run the capture program it gives me a "no device present" message. I know that i DID disable it at one point or another, but i think that was on a previous install of windows, that wouldn't make it disapear, would it? Does anyone have any ideas?
Reply
Reply
post #2 of 6
10/3/05 at 1:38am
Thread Starter 
any ideas?
Reply
Reply
post #3 of 6
10/3/05 at 5:40pm
try desabling the usb form the bios and then boot into windows. restart again and go to bios and enable it again see if that works
Reply
Reply
post #4 of 6
11/8/05 at 10:12pm
I have two 3880s and one of them has the exact same issue. Did the above suggestion solve your problem?
Reply
Reply
post #5 of 6
11/8/05 at 10:16pm
If that does not work try the following. I found this on another post on this forum:

Quote:
you gotta enable the webcam first in order to use it. I believe it is the FN+8 to activate it. I had the same problem as you at first but after i activated it, it worked.
I have not tried either of these since the laptop in question is my wives and she has it right now.
Reply
Reply
post #6 of 6
11/10/05 at 3:00pm
OK... I can confirm this... It was indeed the fn+F8 problem. Sager should label ALL its FN keys. It is not even in the manual.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home