NotebookForums.com › Forums › Notebook Manufacturers › Dell Notebook Forums › Dell Legacy (single-core notebooks) › Where's the "Overclocking your X300" tutorial?
New Posts  All Forums:Forum Nav:

Where's the "Overclocking your X300" tutorial?

post #1 of 5
1/21/06 at 4:01am
Thread Starter 
Hey you guys, i can't find it! Maybe it's just me, but i can't find it.

Help needed...
Reply
Reply
post #2 of 5
1/21/06 at 4:07am
It's not really that hard. It is just like overclocking any other ATI card. Go to Omegadrivers.net, download that, and use ATI Tray Tools. Let it try and find the max for your memory first, then gpu, then make sure they are stable (you may have to do less than the max ATT found) and then click scan for artifacts. Then run 3DMark05 and tell us how you do!
Reply
Reply
post #3 of 5
1/21/06 at 2:19pm
Thread Starter 
How can i check if the settings are stable? Do I have to use like Prime95 of something like that?
Reply
Reply
post #4 of 5
1/21/06 at 2:22pm
Well ATI tray tools has a benchmark utility. now you can turn on the 3d renderer manually too (by clicking show 3d renderer in the hardware section) just leave that on for a while. Other than that just run a game. anything over an hour and its as stable as it will get.
Reply
Reply
post #5 of 5
1/21/06 at 7:24pm
Run the 3D Render and have it scan for artifacts. Let it run for a while, and if it doesn't pick up anything after at least 60 seconds, you should be stable. If you do, you've pushed it a bit to far, and you'll have to back down.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
NotebookForums.com › Forums › Notebook Manufacturers › Dell Notebook Forums › Dell Legacy (single-core notebooks) › Where's the "Overclocking your X300" tutorial?