Hi, first off this seems like a great site! I’m excited to fix my problem with everyone’s help. Here is my story:
I’ve got a Dell Inspiron 1100 which had some overheating issues and, just recently took an unfortunate fall off my coffee table and did a face plant (screen down) on the floor…after that it will not boot and the display will not show up either. The battery will charge and the power light will come on so i do not think it is a power problem. The fan also turns on for about 5-10 secs then stops. The power light remains on until i press the power key again.
Now, i’ve done some research on this site and some others and i was able to open up the laptop correctly following a guide and look at everything. Things look okay (nothing was cracked or anything obvious…) and i basically cleaned the inside using an air can and disconnected the keyboard, monitor, and processor and reconnected them all. The problem was the same.
I read on this site that the cpu might not be seated properly but i don’t know how to clean off the old heat shrink gel stuff and put the new stuff on or anything else i should check for. ram?
Am i on the right track?
any help or other ideas would be appreciated. thanks.
I’ve got a Dell Inspiron 1100 which had some overheating issues and, just recently took an unfortunate fall off my coffee table and did a face plant (screen down) on the floor…after that it will not boot and the display will not show up either. The battery will charge and the power light will come on so i do not think it is a power problem. The fan also turns on for about 5-10 secs then stops. The power light remains on until i press the power key again.
Now, i’ve done some research on this site and some others and i was able to open up the laptop correctly following a guide and look at everything. Things look okay (nothing was cracked or anything obvious…) and i basically cleaned the inside using an air can and disconnected the keyboard, monitor, and processor and reconnected them all. The problem was the same.
I read on this site that the cpu might not be seated properly but i don’t know how to clean off the old heat shrink gel stuff and put the new stuff on or anything else i should check for. ram?
Am i on the right track?
any help or other ideas would be appreciated. thanks.





