NotebookForums.com › Forums › Notebook Manufacturers › Sony Notebook Forums › Sony Notebooks › NO INPUT message when I open VAIO Camera Capture Utility
New Posts  All Forums:Forum Nav:

NO INPUT message when I open VAIO Camera Capture Utility

post #1 of 3
1/19/08 at 12:39pm
Thread Starter 
Sony VAIO VGN-FZ250E

I bought a Sony Vaio and installed all the drivers from the SOny Vaio Support Site. The only that is missing shown in the Device Manager is "Mass Controller Device" I don't know which driver for that would solve the problem.

Problem: NO INPUT message when I open VAIO Camera Capture Utility
Operating system: Windows Vista Home

Please help me activate my Integrated Camera Utility..
Reply
Reply
post #2 of 3
5/2/09 at 3:05pm
i have a vgn-fz38m and suddenly i have same problem. may you help me to solve it? moth_REMOVEMEcosacco @ hotmailREMOVEME . com
Reply
Reply
post #3 of 3
6/18/09 at 3:34am
I had this problem with my VAIO VGN running 32 bit Vista (no input blue screen on the camera capture utility). The camera and utility was working fine when I first bought the laptop. I then had a corrupt hard drive replaced and the electronics store from which I bought the laptop attempted to re-install all of my vista/vaio drivers. I noticed the device manager had 'USB Camera' listed under imaging devices so I re-installed the camera driver for my laptop from the sony website: esupport.sony.com (enter model #)--> drivers & software --> camera --> Original - Sony® Visual Communication Camera VGP-VCC8 . Once I ran this install and restarted, the device manager had the Sony Camera listed instead of USB Camera and I was good to go. This may not work for everyone but it worked for me... hope this helps!
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Sony Notebooks
NotebookForums.com › Forums › Notebook Manufacturers › Sony Notebook Forums › Sony Notebooks › NO INPUT message when I open VAIO Camera Capture Utility