HOW-TO: Overclock 9262 *q6600* to 3ghz/1333mhz FSB

i sux0r at guides but have no problem sharing knowledge.

enjoy.

I have been working with this notebook alot.

I have sucessfully found the best bios combo for overclocking the GPU and CPU.

the CPU Overclocking is multiplier locked so what you have to do is what's called a pin mod.

these new CPU's have different pins than the good o'le days so it makes it easier.

My mod I did with simple Black electrical TAPE!

yes that's right TAPE.

Here is what you do.

Remove your q6600 CPU from the socket.

take the 8 screws from the d901c/9262 and remove cover

then remove fan that houses RAM *over the ram.

3 screws.

then remove 4 screws in order of 1-4 and remove the heat sync. there is a plastic handle to pull it out.

then remove CPU and take a piece of black tape and put it on a smooth board.

then using an exacto blade (box cutter) ---Al-Keida!!!

cut a small square/rectangle chunk out.

it may take you a few tries.

then put it over the Bsell *pin* like so.



after put back in socket. put on as5 or other lube... and way you go.

Make sure to keep Fans on MAX fn +1

My temps are as follows

idle 38 degrees always max fans.

max with crysis is 55 degrees.

and absolute max with TAT is 67 degrees

use Coretemp for best true temps

and your good to go.

I will post an howto for the GPU that shows how to mod the bios voltage table and get every last ounce of juice/power out of the 8800m

and unlock the shader clock past 1350..

thanks ZX, been modding the crap outta this beast.

no.

you allready have 1333mhz fsb and 3.0ghz

it's meant for the q6600 only.

this mod makes your processor better than almost every one on the market for quads and even better than the q9550 in terms of computing power.

it matches the qx6800 @stock