post #1 of 1
4/21/08 at 9:43pm
Thread Starter 
I've got a I6000 with a radeon x300, with the omega drivers, and something weird has happened. For the longest time I was using an external monitor setup (saved space on my desk) with no problems. The monitor I used had 1280x960 res...worked perfectly fine. Also have a projector with similar max res, maybe a bit higher, but regardless it worked fine. I then hooked my laptop to a new Dell HD monitor and ran it at 1440x900 (?) res...whatever widescreen vertical goes with 1440. Anyway, now ONLY that monitor works for dual/clone monitor setups. I hook up the older monitor/projector and it's as if there is no output. The display settings show that both monitors are enabled and working fine, but the external monitor shows nothing. The monitor just stays on standby, and the projector says it detects no input. I'm relatively certain I changed some sort of setting within the omega advanced settings because I remember having to go through a bit of trouble to get the HD monitor to display a non-stretched out image. Argh help...I'm going crazy trying to figure this out!
Reply
Reply