Easy unlimited access to hidden PQService!! - Page 2

Hi

when i get to the last step, "assign letter=f", i receive a message saying: "DiskPart has encountered an error: the directory is not empty..."

How can I fix this?

hi..i followed the step but am stuck at id for partition type..the step only state the partition types 27 and 12 with their respective id..mine shows partition type 0c which i couldn't find its id...any help?...pliz email me (barcotuba@gmail.com)

thanks...

Thanks for this!! I have wanted for so long to do this but because I had configured my netbook to dual-boot to windows7, alt-F10 no longer works and the Acer eRecovery Mgt tool doesn't do anything - I knew I had the hidden partition but couldn't get to it . . . your instructions saved me! Thanks!

Press "win + r" to bring up the run window
Type: "cmd", to bring up the command window
Type: "diskpart", a new command window pops up with a "Diskpart >" prompt
Type: "rescan", a configuration check runs
Type: "list disk", a list of the available disks appears
Type: "select disk 0", if your hidden partition resides on that disk of course
Type: "list partition", to find out with partition is your hidden one (probably about 10 gb and without name)
Type: "select partition 1", if that is your hidden partition
Type: "detail partition", here you will see the partition type, take a note of that so that you can reset it to the original if needed.
If your partition type = 27 you should enter id=07 in the step below, if type = 12 enter id=0B in the step below.
Type: "set id=07 override", where 07 is the number from the step above - to unhide your partition
 

Everything worked until the last step above. It appeared that "set id=07 override" was mis-spelled or an invalid request. A list of commands appeared and the id always remained at "27"

Any suggestions?