I have a laptop computer toshiba satellite A200
I cut the device does not work and became
Now when I run the device shows the screen to flash at once, knowing that the green light and fan operating system works
Does not appear on the screen but is only the first flash remains black
I have the experience of a usb floppy disk and used outside of this method
1.Disconnect the power cable.
2.Press and hold Fn + B.
3.While holding Fn + B, plug in the power cable. At this point you may notice a brief flash on the screen, which is a good sign.
4.While still holding Fn + B, press power on.
5.Release Fn + B.
6.The system should now boot in Crisis Recovery Mode
But I have no response from the usb floppy disk But I am beginning the installation of cable in AC I hear the voice of a floppy disk and then disappear
Do you find you have a solution
thanks all
I cut the device does not work and became
Now when I run the device shows the screen to flash at once, knowing that the green light and fan operating system works
Does not appear on the screen but is only the first flash remains black
I have the experience of a usb floppy disk and used outside of this method
1.Disconnect the power cable.
2.Press and hold Fn + B.
3.While holding Fn + B, plug in the power cable. At this point you may notice a brief flash on the screen, which is a good sign.
4.While still holding Fn + B, press power on.
5.Release Fn + B.
6.The system should now boot in Crisis Recovery Mode
But I have no response from the usb floppy disk But I am beginning the installation of cable in AC I hear the voice of a floppy disk and then disappear
Do you find you have a solution
thanks all
