I have one of those old D500P/5680. I bought a compatible 120watt power supply and it does not have the 'sager' connector. I never tested the power output pins on the old 'glowing brick' power supply when it was working.
Looking at the business-end of the power-supply plug, with the flat side up, what are the voltage readings of those four pins?
Looking at the business-end of the power-supply plug, with the flat side up, what are the voltage readings of those four pins?
Thanks.
Edit: Found it! http://www.wheelhouse.org/power/index2.html
Edit: Fixed the supply. There was some blown-off solder near a toroid. After resoldering, I found a blown 15amp fuse, a little red rectangle near the plug-end, labeled T3,15A. 50 cents to replace.
Edit: Fixed the supply. There was some blown-off solder near a toroid. After resoldering, I found a blown 15amp fuse, a little red rectangle near the plug-end, labeled T3,15A. 50 cents to replace.
