NotebookForums.com › Forums › Notebook Manufacturers › Gateway Notebook Forums › Gateway Notebooks › Lid badge replace/remove
New Posts  All Forums:Forum Nav:

Lid badge replace/remove

post #1 of 4
12/22/04 at 1:55am
Thread Starter 
I've always been a fan of custom case badges, but the big E on my 6811 is not shaped like any I've seen. Also, I'm not sure what's beneath it. I want to make sure I can put a clean looking replacement badge before I try peeling it. Has anyone removed the big E from the center of the lid?
Reply
Reply
post #2 of 4
12/22/04 at 2:13am
No, but I want to know what your planning on putting there.

HD
Reply
Reply
post #3 of 4
12/22/04 at 10:31am
Thread Starter 
My brother has a plotter/printer that does really nice stickers and vinyl cutouts, so I could do anything. I don't want to find out the surface below is all jagged after I peel the logo. Another issue is, it's on there pretty tight.
Reply
Reply
post #4 of 4
12/22/04 at 2:55pm
*Nods*

Yeah, I noticed that. The sticker/decal must be embedded into the high quality tungsten lid of the notebook. Honestly, I don't like the whole back at all, wish it was all one color.

I am not a big fan of putting stickers on my notebook either, but I think I may do this one, because it looks nice:

http://www.hackerstickers.com/produc...e-hacker.shtml

But the whole "e" thing bugs me. I was planning on getting the white one and putting it under the "e" right above the hinges.

HD, loving his notebook, hating the look of it.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Gateway Notebooks
NotebookForums.com › Forums › Notebook Manufacturers › Gateway Notebook Forums › Gateway Notebooks › Lid badge replace/remove