New Posts  All Forums:Forum Nav:

refresh rate

post #1 of 6
12/26/02 at 5:24pm
Thread Starter 
How high can i set the refresh rate on my 5660 lcd?
Reply
Reply
post #2 of 6
12/26/02 at 5:52pm
Just leave it at default 60. You won't see a difference since LCDs don't refresh the way CRTs do where you would see the flicker in the CRT if it was set too low.
LL
LL
LL
Reply
Reply
post #3 of 6
12/27/02 at 1:32am
LCDs dont' support higher than 60hz if I'm not mistaken... that's the best setting, they look spectacular :-)
Reply
Reply
post #4 of 6
12/27/02 at 4:35am
Thread Starter 
its just that i have been getting lines rolling through the display during some video playback and during some of the 3dmark tests.
Reply
Reply
post #5 of 6
12/27/02 at 8:04pm
You should try removing and then re installing your video card drivers, I used to have the same problem, but I installed them again and it fixed it.
Reply
Reply
post #6 of 6
12/28/02 at 2:45am
Agreed, or while you are at it, you could go for the latest 6218 drivers (assuming those aren't what you've been using). But yes, drivers should fix that problem. If not, try different video playback programs to see if it happens with all of them. Good luck!
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Sager & Clevo Notebooks