How to prolong lithium-based batteries
Battery research is focusing heavily on lithium chemistries, so much so that one could presume that all portable devices will be powered with lithium-ion batteries in the future. In many ways, lithium-ion is superior to nickel and lead-based chemistries and the applications for lithium-ion batteries are growing as a result.
Lithium-ion has not yet fully matured and is being improved continuously. New metal and chemical combinations are being tried every six months to increase energy density and prolong service life. The improvements in longevity after each change will not be known for a few years.
A lithium-ion battery provides 300-500 discharge/charge cycles. The battery prefers a partial rather than a full discharge. Frequent full discharges should be avoided when possible. Instead, charge the battery more often or use a larger battery. There is no concern of memory when applying unscheduled charges.
Although lithium-ion is memory-free in terms of performance deterioration, batteries with fuel gauges exhibit what engineers refer to as "digital memory". Here is the reason: Short discharges with subsequent recharges do not provide the periodic calibration needed to synchronize the fuel gauge with the battery's state-of-charge. A deliberate full discharge and recharge every 30 charges corrects this problem. Letting the battery run down to the cut-off point in the equipment will do this. If ignored, the fuel gauge will become increasingly less accurate. (Read more in 'Choosing the right battery for portable computing', Part Two.)
Aging of lithium-ion is an issue that is often ignored. lithium-based batteries have a lifetime of 2-3 years. The clock starts ticking as soon as the battery comes off the manufacturing line. The capacity loss manifests itself in increased internal resistance caused by oxidation. Eventually, the cell resistance will reach a point where the pack can no longer deliver the stored energy, although the battery may still contain ample charge. Increasing internal resistance is common to cobalt-based lithium-ion, a chemistry that is found in laptops and cell phones. The lower energy dense manganese-based lithium-ion, also known as spinel, maintains the internal resistance through its life but loses capacity due to chemical decompositions.
The speed by which lithium-ion ages is governed by temperature and state-of-charge. Figure 1 illustrates the capacity loss as a function of these two parameters.
Figure 1: Permanent capacity loss of lithium-ion as a function of temperature and charge level.
High charge levels and elevated temperatures hasten permanent capacity loss. Improvements in chemistry have increased the storage performance of lithium-ion batteries.
There are no remedies to restore lithium-ion once worn out. A momentary improvement in performance is noticeable when heating up the battery. This lowers the internal resistance but the condition reverts back to its former state when the temperature drops.
If possible, store the battery in a cool place at about a 40% state-of-charge. Some reserve charge is needed to keep the battery and its protection circuit operational during prolonged storage. The most harmful combination is full charge at high temperature. This is the case when placing a cell phone or spare battery in a hot car. Running a laptop computer on the mains has a similar temperature problem. While the battery is kept fully charged, the inside temperature during operation rises to 45°C (113°F).
Removing the battery from the laptop when running on fixed power protects the battery from heat but some battery and laptop manufacturers caution against it. They say that dust and moisture accumulating inside the battery casing could damage the laptop. The dealers will be happy to provide you with a new pack when a replacement is needed a little sooner.
The question is often asked if one should disconnect the laptop from the main when not in use. With lithium-ion it does not matter. Once the battery is fully charged, no further charge is applied. It is recommended, however, to turn the laptop off overnight because of heat harms the battery.
A large number of lithium-ion batteries for cell phones are being discarded under the warranty return policy. Some failed batteries are sent to service centers or the manufacturer, where they are refurbished. Studies show that 80%-90% of the returned batteries can be repaired and returned to service.
Some lithium-ion batteries fail due to excessive low discharge. If discharged below 2.5 volts per cell, the internal safety circuit opens and the battery appears dead. A charge with the original charger is no longer possible. Some battery analyzers (Cadex) feature a boost function that reactivates the protection circuit of a failed battery and enables a recharge. However, if the cell voltage has fallen below 1.5V/cell and has remained in that state for a few days, a recharge should be avoided because of safety concerns. To prevent failure, never store the battery fully discharged. Apply some charge before storage, and then charge fully before use.
All personal computers (and some other electronic devices) contain a battery for memory back up. This battery is commonly a small non-rechargeable lithium cell, which provides a small current when the device is turned off. The PC uses the battery to retain certain information when the power is off. These are the BIOS settings, current date and time, as well as resource assignment for Plug and Play systems. Storage does shorten the service life of the backup battery to a few years. Some say 1-2 years. By keeping the computer connected to the main, albeit turned off, a battery on the PC motherboards should be good for 5-7 years. A PC should give the advanced warning when battery gets low. A dead back-up battery will wipe out the volatile memory and erase certain settings. After battery is replaced, the PC should again be operational.
•Avoid frequent full discharges because this puts additional strain on the battery. Several partial discharges with frequent recharges are better for lithium-ion than one deep one. Recharging a partially charged lithium-ion does not cause harm because there is no memory. (In this respect, lithium-ion differs from nickel-based batteries.) Short battery life in a laptop is mainly cause by heat rather than charge / discharge patterns.
•Batteries with fuel gauge (laptops) should be calibrated by applying a deliberate full discharge once every 30 charges. Running the pack down in the equipment does this. If ignored, the fuel gauge will become increasingly less accurate and in some cases cut off the device prematurely.
•Keep the lithium-ion battery cool. Avoid a hot car. For prolonged storage, keep the battery at a 40% charge level.
•Consider removing the battery from a laptop when running on fixed power. (Some laptop manufacturers are concerned about dust and moisture accumulating inside the battery casing.)
•Avoid purchasing spare lithium-ion batteries for later use. Observe manufacturing date. Do not buy old stock, even if sold at clearance prices.
•If you have a spare lithium-ion battery, use one to the fullest and keep the other cool by placing it in the refrigerator. Do not freeze the battery. For best results, store the battery at 40% state-of-charge.
Created: February 2003, Last edited: January 2005
About the Author
Isidor Buchmann is the founder and CEO of Cadex Electronics Inc., in Vancouver BC. Mr. Buchmann has a background in radio communications and has studied the behavior of rechargeable batteries in practical, everyday applications for two decades. Award winning author of many articles and books on batteries, Mr. Buchmann has delivered technical papers around the world.
Cadex Electronics is a manufacturer of advanced battery chargers, battery analyzers and PC software. For product information please visit www.cadex.com