New Posts  All Forums:Forum Nav:

Flashed with WinPhlash... now they want to debug my array

post #1 of 4
4/19/05 at 6:29pm
Thread Starter 
Hello All,

I just wanted to innocently flash my bios, install new bios from the sager site. Downloaded, installed winPhlash... and then ran the flash software for the new bios. it restarted, flashed...

"operating system not found"
rebooted...
and entered a new utility FastBuild, asking me to build an array (which is apparently for my harddrive). I did so, and tried to reboot.
Windows came up for a sec (booting screen) but then straight to BSOD, and reboots before i can read any errors...

Tried safe mode, no luck. I'm quite lost as to what I'm doing with the ARray building doohicky.

Any help would save me - as I'm without pc...

-Thanks!
morris
Reply
Reply
post #2 of 4
4/19/05 at 8:15pm
Thread Starter 
was able to cure this, quite easily (/me slaps the side of his head)

the flash reset the bios settings (but of course) -- which switched it to a raid setup. once i set it back to ATA - i was all good.

just in case someone else has the same fret..
Reply
Reply
post #3 of 4
4/21/05 at 2:37pm
the bios update did not reset my raid setup so i had no troubles.
Reply
Reply
post #4 of 4
4/21/05 at 7:45pm
It didnt reset yours because you are already on raid. Flashing the bios turns the setting to raid so those with single setups have to switch to ata, whereas those on raid notice no difference.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home